TWOPAGES Custom Curtain Fireproof Flame Retardant Thermal Insulated Curtain Drapery 1 Panel

Custom made information required: 1. Header: Nickel Grommet/ Antique Bronze Grommet/ Tab Top/ Rod Pocket/ Goblet/ Pinch Pleated/ Back Tab/ Flat Hooks. 2. Single Panel Width__inch and Length: __inch. Measure your rod or track, and decide curtain width. 3. Color. 4. Lining Type: Unlined; Privacy Lining (cotton blend in white, 100 gsm); Blackout Lining (140 gsm weight, white); Thermal blackout lining ( 200 gsm microfiber with white foam coated). Grommet Top Inside diameter of grommet 1.6"(4cm), outside diameter of grommet is 2.25"(5.4cm). Measure the drop from the top of pole or rod to where you want curtain to finish.If rod length 100", add 2x fullness for folds and overlap, then order 2 panels of each 100" wide. Pinch Pleat Pleat length 3-1/8 inches. Pleat depth 1 inch. White back tape width 3-1/8 inches. Side hem 1 inch, bottom hem 4 inches. Pleats space apart 5.5-6.5 inches. Goblet Goblet height 3.5 inches (9 cm). Side hem 1 inch (2.54 cm), bottom hem 4 inches (8 cm). Goblet space apart 5.5-6.5 inches. Flat Hook Header height 3 inches. Pin hooks height 3 inches, adjustable height up and down. 6 pin hooks included per 40 inches width. Side hem 1 inches, bottom hem 4 inches. Measure length from the eye ring to bottom. Rod rings not included., which need to purchased separately. The max achievable finished single curtain width is 106 inches for grommet, tab top, rod pocket header style, 58 inches for pinch pleat, if the length is over 102 inches. The maximum achievable finished single curtain length is 102 inches, if the width is over 106 inches for grommet rod pocket style.

• Inherently flame retardant fire resistant. Extinguish immediately when leave the fire, non-toxic, smockless, eco-friendly. United States NFPA701 flame retardant standard Certified.
• WIDTH: For pinch pleat, goblet header, panel width is the width after pleats already set, we recommend fullness ratio 1.0-1.2 times wide of your curtain rod or track. For tab top and rod pocket header, we recommend fullness ratio 1.0-1.2 times wide of your curtain rod. For grommet header, we recommend fullness ratio 1.5-2 times to create the waves and folds when close the curtains. For flat hook and back tab header, we recommend fullness ratio 1.25-2 times wide of your curtain rod.
• LENGTH: For grommet, rod pocket, back tab and tab top header, measure from the top of rod to where you want the bottom of the drapery to be (1/2" above the floor, or approximately 6" to 8" below the window sill ). This is your finished top of pole to hem drop. For flat hook, pinch pleat and goblet header, measure from bottom of rings to top of floor or top of window sill, depending on desired window coverage. Subtract 1/2" to get the panel length you need.
• The front and back are the same color. Wash by hands or gentle cycle. Iron them in low temperature. Do not pull down the grommets.
• Fit for living room, bedroom, patio door, club, hospital, room divider.